SPECIAL LIMITED TIME PROMOTION Learn More About Our Window Line-Up Learn More About Our Door Line-Up Our Expertise www.pellethead.com Be Sociable, Share! TweetFull Article
2016 Customer Appreciation Weekend For 23 years now we have been hosting our Annual Customer Appreciation Weekend! It’s our little way of saying thanks and giving back to all of our amazing customers. Thank You! Come on out for burgers,...Full Article
Earth Sense Energy Systems is the 2016 Vesta Award Winner for Hearth Retailer of the Year! This is the most prestigious award in the industry. From a piece of dirt and a dream… 25 years in the making. Congratulations to...Full Article
Earth Sense has one of the largest NFI technical staffs in the Country! We are happy to provide troubleshooting assistance and we provide full in-home service programs throughout Wisconsin. Harman Stove Making Noise/Squealing during feed cycle- Scott Writes In: We...Full Article
William Writes In- Problem with the pellet feed on an Original Mt Vernon 4 speed, board Number 7000-126. Recently replaced the system control board. Getting blue flashing light at start and a green light. No red light in controller, red...Full Article
The importance of cleaning your pellet stove exhaust/combustion fan regularly cannot be emphasized enough. As a general rule of thumb you should clean your exhaust motor and exhaust venting after 3 tons of pellet fuel have been burned. If you...Full Article
Free shipping on orders over $49* *Standard Shipping On Parts and Accessory Orders in the Continental U.S. Only.
Please ensure you require this control board prior to ordering. We are unable to return circuit boards that have been installed or used in anyway. Be sure to check all wiring and components prior to installing a new control board. We are happy to assist with technical support.
3 in stock (can be backordered)
~ Empress FS
~ Empress Insert
~ 120V AC
~ Single Fuse- Replaces double fuse board
~ 3 Modes of Operation
~ Genuine OEM
*Further control board notes are below
** 100% Best Price Guarantee
** 100% Satisfaction Guarantee
** 100% On-Time Shipping Commitment
** No Returns Accepted
Over 20 years of trusted value and commitment to our customers.
Empress board part number 50-1369 replaces the factory circuit board with double fuses. This new circuit board does not have J9 jumper like the earlier board. The 4 pin bank is a feed rate control; the jumper should remain in the middle with one pin exposed on either side. The 5 pin bank controls thermostat function. From factory it is toward the top with 3 pins showing; this is manual mode. Moving the Jumper to the next two pins puts it in hi/low thermostat mode. Covering the last two pins will put the stove into On/Off thermostat mode.
Once set, you will have to push the start button with the thermostat up calling for heat. Unlike the original 2 fuse board, this control board takes a full 30 minutes before it “locks-in” and will recognize the thermostat. When running in the on/off thermostat mode, the unit will still go to a low/pilot fire for 15 minutes when the thermostat is satisfied before shutting down- The original board would shut down the stove immediately.
|Dimensions||8 x 3 x 2 in|